So if you change your device entry to:ĭevice = Serial:Reader 67, the smargo will be picked up with no need to manually change it's bus/device address.Īt the moment I run oscam 3326 on Debian and it works very well.ĮDIT: that was meant to be sent in General section so pls if admin can shift it there, thanks.īDeviceClass 0 (Defined at Interface level) In that case the " iSerial 3 Reader 67" is of interest to us. In rver you need to change familiar Device = bus:device to Device = Serial:Reader XXX where XXX represents serial number of smargo found from webif usb scan script (lsusb does not show smartreader number), i.e:īus 001 Device 003: ID 0403:6001 Future Technology Devices International, Ltd FT232 USB-Serial (UART) IC What you need is make sure your smartreader is updated to v. The advantage of it is that you will not have to change bus/device settings in your rver file every time you restart PC or unplug smartreader. ![]() ![]() Recent changes in oscam/smargo allow you to define device by reader number rather then bus/device. ![]() I did not see any post on our forum in that subject so (appology if it was discussed) i think it might be useful for some members.
0 Comments
Leave a Reply. |