![]() A good practice is to test the block after each change to catch any errors early. On Block Editor contextual tab, Open/Save panel, click Test Block to test the block before you save it. Consider how geometric objects might be affected if actions are chained together. ![]() ![]() Parameter properties affect grips, labels, and preset values for the block geometry. the directions and values that can affect how geometry in the block might be manipulated.Īdd actions to define what will happen to the geometry when it is manipulated.Īdd properties that determine how the block is displayed in the drawing area. Specify the dimensional constraints from the Constraints tab on the Block Authoring palette.Īdd parameters to specify which objects will be affected by an action. It usually makes sense to add constraints to the geometry first, before adding parameters and actions. If you plan to use visibility states to control when geometry is displayed, you might not want to include all the geometry at first.Īdd geometric and dimensional constraints (not in AutoCAD LT) For example, you might decide that the block should be able to be resized in a specific direction, after which additional geometry is displayed.Ĭreate the geometric objects for the block in the Block Editor. ![]() Plan how the block should change or move, and what objects will depend on the other objects. The following table provides an overview of the steps required add dynamic behaviors and controls to a block definition.
0 Comments
Leave a Reply. |